One-step Ketamine Test (Strip)
One-Step Ketamine Test is a one step, lateral flow chromatographic immunoassay for the qualitative detection of Ketamine and its metabolites in human urine. The test cut off is 1000ng/ml.
Instruction for use
Principle of Test:
Cut-off Level: 1000 ng/ml
INTENDED USE: One-Step Ketamine Test is a one step, lateral flow chromatographic immunoassay for the qualitative detection of Ketamine and its metabolites in human urine. The test cut off is 1000ng/ml.
SENSITIVITY OF THE TEST
MOP-300ng/ml, MET-1000ng/ml, KET-1000ng/ml, MDMA-500ng/ml, COC-300ng/ml, THC-50ng/ml,
AMP-1000ng/ml, BAR-300ng/ml, BZO-300ng/ml, MTD-300ng/ml, PCP-25ng/ml, BUP-10ng/ml,
TCA-1000ng/ml, OXY-100ng/ml, PPX-300ng/ml, OPI-2000ng/ml.
1.Bring the pouched test strip to room temperature (15-30℃) prior to testing. Do not open the pouch until ready to perform the assay.
2. Remove the test strip from the sealed pouch.
3. Immerse the test strip in the urine specimen with the arrow end pointing toward the urine. Do not immerse the strip above the printed MAX line.
4. After a minimum of 15 seconds, remove the test strip from the urine and lay flat on a non-absorptive clean surface. Alternatively , leave the test strip in the urine specimen as long as the strip is not immersed above the MAX line.
5. Read results between 3-8 minutes. Do not read results after 10 minutes.
INTERPRETATION OF RESULTS
Negative: Two red lines are visible, one in the test region (T) and another one in the control region (C). No matter the color intensity of the test line is weaker or stronger than that of the control line, the test result is negative.
Positive: Only one red line visible in the control region (C) and the absence of the test line indicates a positive result.
NOTICE: A very faint line in the test region indicates that the ketamine in the specimen is near the cut-off level of the test. These specimens should be retested or confirmed with a more specific method before a positive determination is made.
Invalid: The test is invalid if the control line is not visible regardless of the presence or absence of the test line.
NOTICE: Insufficient specimen volume or incorrect procedural techniques are the most likely reasons for the control line failure. Review the procedure and repeat the test with a new device. If problem persists, please contact your local distributor.